Hopper funnel for FillOmat filling machine

01 · HOW IT WORKS

By gravity, from above

The hopper mounts on the Fillomat inlet with its flange and fixing holes, without special tools, and is filled from the top: the cone channels the honey to the pump with no corners where it is held back, and the machine doses as always. It serves to bottle what is in a bucket without going through the tank, for thick honeys the hose sucks badly, and to change honey without emptying tubes: run the hopper down and load the next.

02 · THE MATERIAL

Polished stainless, comes off to wash

Stainless steel with a polished surface, so the honey slides and no residue is left between batches; when you finish it comes off and is washed in hot water. It is the same family of steel as the filler’s circuit, with nothing to give taste to the honey.

03 · WHAT IT GOES WITH

Only the Fillomat

The flange is the Fillomat inlet’s (2365): it is no use on other fillers. From the same machine: elbow 2415, elbow with tap 2416, anti-drip nozzle 2892, centring bracket 2960, level sensor 2268 and turntable 3321.

04 · BEFORE YOU BUY

The hopper is supplied on its own; the filler comes separately.