Lock nut for taps 33/42 (1 1/4")

Share in WhatsApp

1 .95 €

Tax included

Stock

33/42 (1¼ in) plastic locknut for securing a compatible tap from inside a tank or drum without an integral threaded socket. Retaining component only; tap and sealing gasket are not included.

1 .95 €

Tax included

Stock

Quantity

Select options Options

Express Shipping

Return Guarantee

Safe payment

Details of Lock nut for taps 33/42 (1 1/4")

A 33/42 (1¼ in) plastic locknut for securing a compatible tap from inside a tank or drum that has no integral threaded socket.

It is used where the container has a plain opening and the threaded tap body passes through the wall. The nut clamps the assembly from inside; it is not a complete tap and does not replace the sealing gasket.

01 · PURPOSE

Locks the tap against the container wall

Pass the threaded tap body through from the outside and screw the nut on internally until the fitting is held evenly. This mechanical retention stops the tap turning or pulling out of its mounting during use. Tighten without distorting the wall or overloading the plastic thread; excessive torque can damage the component or the vessel.

02 · COMPATIBILITY AND SEALING

The 33/42 thread must match and a gasket is still required

The nut is nominal size 33/42, equivalent to 1¼ in. Check the tap's male thread, access to the inside face and the container wall thickness. A watertight joint depends on a compatible gasket seated on a clean, flat surface; this nut provides retention but neither includes nor replaces that seal.

03 · BEFORE BUYING

A replacement component, not a complete fitting kit

You need a tap with a matching male thread and a container prepared with a suitable opening. Verify the size from documentation or a known component rather than the approximate diameter alone. One plastic locknut is supplied. Tap, gasket, tank, tools and drilling template are not included.

LOCKNUT DETAILS

Reference	00389
Type	Internal tap retaining nut
Material	Plastic
Nominal size	33/42
Equivalent size	1¼ in
Fitting position	On the tap thread, inside the container
Purpose	Mechanical retention of the tap
Not included	Tap, gasket, tank or tools