Honey hose holder 2"

Share in WhatsApp

36 .90 €

Tax included

Curved stainless-steel support for guiding a 50 mm (2-inch) honey hose over the rim of a drum or settling tank. Its rings reduce tight kinks and direct the outlet inwards. Check the hose’s outside diameter and the vessel rim before use.

36 .90 €

Tax included

Quantity

Select options Options

Express Shipping

Return Guarantee

Safe payment

Details of Honey hose holder 2"

Curved stainless-steel support for guiding a 50 mm (2-inch) honey hose over the rim of a drum or settling tank.

It keeps the final section raised and directed into the vessel. This is a rest, not a clamp: the fit depends on the hose’s outside diameter and the shape of the rim.

01 · WHAT IT SOLVES

A stable entry without tight kinks

The three rings guide the hose through a broad curve, while the hooks rest the assembly on the vessel. This reduces the risk of a tight bend restricting the flow and keeps the hose outlet directed towards the inside.

02 · SET-UP

Check the support before starting the pump

With the pump stopped, pass the hose through the rings and hang the hooks over a firm rim. Centre the outlet, leave enough slack to prevent the hose pulling on the support and test at low flow. Do not use it to hold the pump, rigid pipework or a long suspended hose section.

03 · BEFORE YOU BUY

The nominal 2-inch diameter is not enough

Measure the hose’s actual outside diameter: two hoses with a 50 mm bore can have different wall thicknesses. Check the rim geometry as well. After use, wash with warm water and food-safe detergent, rinse and dry; avoid steel wool and concentrated chlorine.

TECHNICAL DETAILS

Web reference	SOP8362
Type	Curved support with three guide rings and resting hooks
Material	Stainless steel for food contact; grade not specified
Nominal hose	50 mm (2 inches)
Catalogued weight	0.5 kg
Declared manufacture	Spain
Check required	Hose outside diameter and vessel rim
Not included	Hose, pump, fittings or vessel