Original SAF electronic board for Eco motors, ideal to bring stopped extractors back to life without replacing the whole motor. Compatible with models such as Ibiza, Kadett, Regata, Fuego, Ritmo and Racing manufactured roughly between 2010 and 2024. Quick plug and play replacement by copying the existing wiring. Before ordering, open the control box and check that your board matches the one shown in the photos.
Original SAF Eco control board: brings the extractor back without replacing the motor or the whole box.
When a SAF extractor stops dead, it is hardly ever the motor. What usually fails is the board that governs speed and direction inside the control box. Replacing the whole motor is expensive and often unnecessary: the board brings the machine back for a fraction of the cost.
01 · BEFORE YOU SPEND THIS
An extractor that «has stopped and will not start» has more than one possible cause, and they do not all cost the same. The cheapest is the lid detector: if honey gets into the plunger and the stem stops returning, the machine believes the lid is open and gives the motor no power. That microswitch costs under ten euros.
It is worth ruling out first. With the machine unplugged, press the plunger with a finger and check that it springs back. If the lid responds properly and the box still will not drive the motor, then yes — the board is the suspect.
02 · UNPLUG IT FIRST
The swap takes minutes, but it is done with the machine disconnected from the mains: there is supply voltage inside that box. Opening the panel with the machine plugged in is not an option.
Then the order that never fails: a phone photo of the wiring on the old board, disconnect, fit the new one copying exactly the same position for every wire, and close up. The photo is what turns a delicate job into a trivial one.
03 · 2010-2024: AFTER THAT, ANOTHER BOX
This board belongs to the SAF Eco motor line, the grey or black ones fitted to Regata, Ritmo, Racing, Kadett, Fuego, Ibiza and similar machines built roughly between 2010 and 2024.
The same trade names carry on in the catalogue with different electronics from 2025, which no longer take this board but a different complete control box. That is why the extractor model is no use for deciding: you have to look at the part.
04 · COMPARE YOUR BOARD WITH THE PHOTO
Before ordering, open the control box and compare the board you have with the one in this product's images: component layout and terminal positions. If it matches, this is the right reference.
And a maintenance note, because the fault almost always comes from the same place: an extraction room is damp, steam and airborne honey. The control box appreciates being kept properly closed and not left open through the season.
05 · BEFORE YOU BUY
An electronic spare, not an accessory.
| ✓ A GOOD FIT | Control boxes for SAF Eco motors (2010-2024) whose board matches the photos. |
| ⚠ RULE OUT THE LID DETECTOR FIRST | It gives the same symptom and costs under ten euros. Check it before changing the board. |
| ✕ NOT FOR THE 2025 MACHINES | From that build the electronics are different. Nor is it the same board as the Málaga ones. |
| Product | Original SAF control board, Eco line |
|---|---|
| Function | Governs speed and direction of rotation |
| Extractors | Regata, Ritmo, Racing, Kadett, Fuego, Ibiza and similar |
| Build years covered | Approximately 2010-2024 |
| Replacement | Direct, copying the original wiring |
| Check first | Compare the board with the product photos |
| Before opening | Machine disconnected from the mains |
| Reference | PLACA-ECO-SAF |
Data sheet
Original SAF electronic board for Eco motors, ideal to bring stopped extractors back to life without replacing the whole motor. Compatible with models such as Ibiza, Kadett, Regata, Fuego, Ritmo and Racing manufactured roughly between 2010 and 2024. Quick plug and play replacement by copying the existing wiring. Before ordering, open the control box and check that your board matches the one shown in the photos.
check_circle
check_circle