Honey jar label dispenser, made of sturdy wood with ergonomic design. Compatible with labels up to 160 mm high and jar diameters from 25 to 90 mm.
Wooden dispenser, 420 × 230 mm, that holds the roll and peels the label off: up to 160 mm tall, and seals for jars from 25 to 90 mm.
With both hands free, the label goes on straight. That is the problem it solves: labelling off a loose roll is what leaves labels crooked and bubbled.
01 · WHAT IT SOLVES
The stand holds the roll and separates the label from its backing: you take it by the edge and it goes straight onto the jar. Over a run of two hundred, what changes is not the minute per jar — it is that all two hundred come out alike.
02 · THE MEASUREMENT THAT RULES
The limit is the label height: up to 160 mm. What decides whether it suits you is not the jar, it is that figure. For lid seals, the range is 25 to 90 mm diameter: from a tasting pot to a kilo jar.
03 · THE JAR, DRY
The adhesive needs dry glass at room temperature: with condensation it will not hold. And the seal goes on after closing, centred first time — once stuck it cannot be repositioned without showing.
04 · BEFORE YOU BUY
A wooden stand: clean it dry, and there is nothing to adjust.
| ✓ FITS | Labelling batches by hand from a roll and having them all come out the same. |
| ✕ DOESN'T FIT | As a labelling machine: here you place the label, the stand only presents it. |
| ⚠ NOT INCLUDED | The labels or the tamper-evident seals. |
| Type | Manual dispenser for roll labels |
|---|---|
| Material | Wood |
| Size | 420 × 230 mm |
| Maximum label height | 160 mm |
| Jar diameter for seals | 25 to 90 mm |
| Cleaning | Dry |
| Not included | Labels or seals |
| Weight | 2 kg |
Data sheet
Write your question
Honey jar label dispenser, made of sturdy wood with ergonomic design. Compatible with labels up to 160 mm high and jar diameters from 25 to 90 mm.
check_circle
check_circle